In my previous post, I put together my build of the Raspberry Pi Laptop, but was unhappy with the fact that my circuit board would be exposed, and there would be loose wires (mainly the USB cable) just freely arched over the Pi.
I decided I should cut a USB pass-through slot in the cover of my Raspberry Pi case, since the USB draped over the circuit board in a simple arc, and laid down very nicely by the HDMI port and USB ports.
So here’s how I did it…
It’s been 4 months since I last posted in here, and there’s good cause for that – I haven’t cared to touch a computer in a technical capacity since shortly after I started this job doing IT support at a university. I’m on my computer all day at work, fixing them around campus, and the last thing I want to do when I get home is tear apart my computer and rebuild it.